RMR Footprint Optic Cut (Also Fits Holosun 407c/507c/508t) for CZ P10

This is a service to cut your CZ P10 slide for a RMR pattern optic. The cut will be .185" deep. The front bosses WILL be milled in to locate the optic as this is the way the optic was designed to be located and this ensures universal fitment for any optic that is in spec. The threaded holes will not break into any of the internal parts of the slide. The holes are threaded 6-32 and you will need 6-32 x 3/8 screws. Please note: The internals (extractor, firing pin etc) must be included on this slide, as we will need to shorten the extractor retaining pin after we cut the slide. We do not need the barrel or recoil spring. If the extractor is not included, you will be responsible for shortening it yourself.

**RMR screws will be included for free.

Recommended Sights for Lower 1/3 Co-witness: Dawson Precision P10 .240" Front Sight / Glock .360" Rear Sight. Please Note: CZ front sights can be difficult to remove if they are tight, if we need to remove your front sight, there is a chance it could get damaged.

IRON LOCATION: Due to the size of the RMR footprint, it will be cut over the top of your factory iron sight dovetail. We will recut a Glock style dovetail behind the optic. At this time we do not offer the irons cut in front of the optic.

COATINGS: There is also an option to add Cerakote or bluing to the slide. We offer the Cerakote in Graphite Black, FDE, ODG, Tungsten and Burnt Bronze and it will be applied to the entire slide. The cold bluing will be applied to just the area we cut and your factory finish will remain everywhere else. This type of finish is not as consistent and visually appealing as the Cerakote, but offers some protection for the bare metal. We also now offer a black nitride coating. The nitride is a much harder finish than the Cerakote and will not wear as quickly. It is similar to many factory coatings and offers a clean uniform black look. We work with a local company to offer the nitride, so lead times are not guaranteed. Estimated 3-4 weeks total turnaround.

THE PROCESS: Once you checkout with your chosen optic cut you will receive an email with instructions on how to ship the slide to us. Please ship us your stripped slide only, we are not an FFL and cannot handle frames! We will complete the cut and/or Cerakote and then ship the slide back to you quickly! You will receive an email once the slide has been shipped back to you.

TIMELINE: Once we receive your slide, we will complete the work in 3 business days (Mon-Fri) or less and get it shipped back to you. This includes coating.

PLEASE NOTE: Your order will be returned to the address that you provide at checkout. Please follow instructions and include a copy of your confirmation email when you ship your slide to us, failure to follow this will result in increased turnaround time.